Disc centrifugal separator is used for the separation of fluid materials, with automatic centrifugal slag discharge device; it is mainly used for the purification of materials in enterprises such as chemical industry, petroleum, food, pharmaceutical, mineral processing, coal, water treatment ships.
Working principle of separator:
After the drum reaches the rated rotating power, the raw materials enter the water distribution mechanism. The working material flows through the filter enters the water guide seat. The water guide seat is introduced into the water diversion plate, then the water diversion plate is evenly distributed to the water sling plate, the water sling plate is thrown into the bottom of the drum. At this time, under the action of centrifugal force, a huge hydrostatic pressure is generated under the piston. The hydraulic piston rises tightly abuts the rectangular sealing ring on the main lock ring of the separator drum to close the slag discharge port of the drum. This is the sealed state. . Next, the raw material enters the rotating drum along the inlet-outlet device the feed inlet pipe to fill the disc gap. Under the action of centrifugal force, the heavy phase solids light liquid are continuously thrown out, the heavy phase solids gather around the drum. The purified material the light liquid gradually rise along the outside of the tray respectively, enter the pressure chamber through the guide hole in the neck cover in the drum cover, then output the separated material under the action of the centripetal pump. The slag chamber can be discharged under working conditions.
When the solid matter in the drum is more more collected, at this time, the raw materials are passed into the water distribution mechanism again, the same process of the upper water distribution mechanism is carried out, but the amount of raw materials passed into the water distribution mechanism per unit time is greater than the upper operation Under the action of water pressure, the piston performs a downward-to-rising work flow. During the descending process, the slag discharge port is exposed. At this time, solid substances some materials are under the action of centrifugal force. It is thrown out of the drum body, enters the slag chamber, is guided to the slag discharge cylinder. It flows out the slag discharge port of the slag discharge cylinder. The piston rises instantaneously after descending, closes against the rectangular sealing ring on the main lock ring of the separator drum. The slag discharge port of the rotating drum makes the equipment enter the sealed state again, the above sealing slag discharge process can be carried out in continuous production.
National free consultation hotline:
Business phone: 0417-2292499 2297699
Company Fax: 0417-7843494
Company Address: Liming Street, Xiongyue Town, Yingkou Economic Technological Development Zone, Liaoning Province